Medium Warning
dE on Viessmann Vitodens 333

Your boiler has lost connection to one of its internal temperature sensors, which means it cannot accurately monitor the heat for one of your heating zones.

Reviewed by the BoilerFaultCodes Editorial Team · Last reviewed

Book a service

This fault should be looked at by a Gas Safe engineer within the next week or two. It may get worse if left.

Technical description

Control mode without room influence - Heating circuit M2 room temperature sensor lead break

What causes this fault?

This fault occurs when the boiler loses signal from the temperature sensor responsible for monitoring a specific heating zone. It is typically caused by a loose connection plug, damaged wiring, or a failed sensor component that can no longer send electrical data to the main control board.

Engineer required

This fault requires a Gas Safe registered engineer. Do not attempt gas-related repairs yourself.

Find a Gas Safe engineer
Search the official register →

Related guides you might find useful

Yellow or orange flame — CO safety

Safety-critical — turn off, read this.

Read →

Is boiler cover worth it?

Break-even maths on monthly cover.

Read →

When to replace your boiler

7 signs repair isn't worth it anymore.

Read →